![]() Managed by Timon G (username UnchartedBull) it allows for easy and clean interactions with and Octoprint server without needing a separate computer or web browser. Why Do I Want to Install an Octodash Touchscreen? Octodash does not replace Octoprint but instead is a front end for the existing installation. Supplies Needed to Install and Octodash Touchscreen on a 3D Printer If you want convenient interactions with your Octoprint interface right from the 3D printer w/o needing a phone or PC? A simple and clean user interface for controlling your Octoprint server? To make your printer the envy of all the other printers in the maker space? Then Octodash is for you.A Raspberry Pi Co m patible Touchscreen (RaveRobot recommends the official touchscreen by Element14). ![]() A Case for Raspberry Pi Touchscreen (purchased or 3D Printed).5 Volt Fan (optional but recommended for the Pi4 and newer).Make, save, and restore backups from this menu.įollow our guide to setting up a Raspberry Pi with Octoprint.Steps to Install Octodash for Octoprint 1) Install Octoprint on a Raspberry Pi A lot of the basic steps such as connecting to the Pi via SSH are covered in the Octoprint setup guide, so even if you already have a working Octoprint installation, give it a read. ![]() It isn’t a bad idea to make a backup of your working Octoprint settings (you have confirmed it is working first right?) from within the settings menu and download them externally before continuing. If you are printing instead of buying your touchscreen case then you should make sure this is done first and all the parts fit. Repetier server touchscreen mode exit install#įor my install on my Ender 3 I decided that I was going to print the case for it and then mount it to the workbench next to the printer as opposed to directly on the printer. This case mounts the screen upside down which is better for my setup wiring but will require some software changes later.Mount the Pi on the back of the touch screen and connect the ribbon cable.Connect the dupont wires to the touchscreen.3) Disconnect Your Pi from the Printer and Connect it to the Touchscreen I may revisit this and make a mount for the Ender 3 later which will be linked here. Repetier server touchscreen mode exit software# Technically this is a picture of my second boot since I’ve already flipped the screen in this image.The touchscreen is connected to the Pi in a few places.Ĥ) Boot the Pi with the Touchscreen and Confirm it is Working Shut down the Raspberry pi and disconnect it from the 3D printer. We haven’t installed anything yet but we want to make sure everything is wired right and that the orientation is correct. The command to open the config.txt file via PuTTYĬheck if the screen is inverted and if so make the following changes to my case mounts the screen upside down it wasn’t correct and I needed to rotate the screen 180 degrees.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |